-40%
V Cut Groove PCB Separating Separator Groove Separator Machine Cutting Machine
V Cut Groove PCB Separating Separator Groove Separator Machine Cutting Machine
V Cut Groove PCB Separating Separator Groove Separator Machine Cutting Machine
V Cut Groove PCB Separating Separator Groove Separator Machine Cutting Machine
V Cut Groove PCB Separating Separator Groove Separator Machine Cutting Machine
V Cut Groove PCB Separating Separator Groove Separator Machine Cutting Machine
V Cut Groove PCB Separating Separator Groove Separator Machine Cutting Machine
V Cut Groove PCB Separating Separator Groove Separator Machine Cutting Machine
V Cut Groove PCB Separating Separator Groove Separator Machine Cutting Machine
V Cut Groove PCB Separating Separator Groove Separator Machine Cutting Machine
V Cut Groove PCB Separating Separator Groove Separator Machine Cutting Machine
V Cut Groove PCB Separating Separator Groove Separator Machine Cutting Machine
V Cut Groove PCB Separating Separator Groove Separator Machine Cutting Machine
V Cut Groove PCB Separating Separator Groove Separator Machine Cutting Machine

V Cut Groove PCB Separating Separator Groove Separator Machine Cutting Machine

$ 329.52

Availability: 32 in stock
  • Voltage: AC110V
  • Height of Lower PCB: ≤10mm
  • Upper Blade Adjust Range: 0-0.59in
  • V-CUT Thickness: 0.6-2.0mm
  • Length of Platform: 290mm
  • Equipment/Component Type: Groove Separator Machine
  • Brand: Unbranded
  • Power: 40 W
  • Inner Side of PCB Range: ≤240mm
  • Height of Upper PCB: ≤20mm
  • Condition: New

    Description

    V-Cut Groove PCB Separating Separator PCB Cutting
    Light Bar Sub Board Machine
    110V
    40W
    Specifications
    - Voltage:
    AC110V
    - Power:
    40W
    -
    V-CUT Thickness:
    0.6-2.0mm
    -
    Upper Blade Adjust Range: 0-0.59in
    -
    Length of Platform: 290mm
    - Height of Upper PCB: ≤20mm
    - Height of Lower PCB: ≤10mm
    - Inner Side of PCB Range: ≤240mm
    Instructions
    1) Connect the power supply and activate the switch.
    2) Adjust the gap between the upper and lower blades.
    3) The upper and lower cutters must be on the same plane, and the error cannot exceed 0.1mm.
    4) Set the cutting stroke and speed.
    How To Adjust The Machine
    1. Make sure that the components on the circuit board will not collide with the body and the blade.
    2. According to the thickness of the circuit board, adjust the height of the upper blade by adjusting the knob.
    Caution
    1. Before use, please pay attention to check the tightening of all screws.
    2. Do not remove the protective cover around the blade under any circumstances to avoid any danger.
    3. This machine is only used for circuit boards with pre-engraved V-cutting, and should not be used for other purposes.
    4. After the work is over, please turn off the power and remove the debris.
    5. When the machine is not working for a long time, please remove the upper and lower cutters and apply oil to protect the machine. Please wipe before use.
    Packing Including
    ✔ 1*V Cut Groove PCB Separating Separator
    On Jul 3, 2024 at 02:38:12 PDT, seller added the following information: